top of page

Auxillary Power Protector (APP-4)

 502000 

​​​

  • 12 Volt operation functions reliably from as low as 8 Volts up to 15 Volts

  • 3 Wire Foreign Chassis to 2 Wire Domestic Chassis Converter Logic

  • Current amplification by providing a power source independent from the OEM wiring

  • Facilitates installation of large auxiliary loads without the risk of damage to OEM wiring

  • Automatically isolates outputs from the power source in the case that voltage drops too low, saving a low battery from complete discharge

  • Compact Design for Easy Installation

  • Shorter wire runs allow convenient access and troubleshooting

Auxillary Power Protector (APP-4)

Basic 6 System

 100935 

Touch Basic-6 PDC

(Power Distribution Center)

 

Electronic Switch Panel – 6 Function
System Includes:

​

  • One Keypad 6 Controller connects to a 20 ft. Keypad Harness

  • One Basic 6 Power Distribution Center (PDC)

  • One 20 ft. Keypad Harness

  • One Legend Sheet and Two Legend Slides

  • Mounting Hardware

​​​

  • 12 Volt Operation

  • Ignition On / Off

  • Multiplex Communications 

  • Interchangeable Legends

  • Legends are Backlit

  • Audio Feedback Features

  • Alarms – Up to Eight (8) Alarm Inputs - Positive and/or Negative

  • Circuit Breaker Protected Loads

​​​​

  • Four (4) 20/30-amp outputs and two (2) 40-amp outputs

  • Output Loads connect to Heavy Duty Output Studs

  • Individual Outputs can be momentary or latching for electrical loads 

  • Field Serviceable (Replaceable Circuit Breakers and Relays)

  • Includes Emergency Override Switching 

  • Waterproof Enclosure with Mounting Feet

  • Easy Installation

  • Installation Manual Included

Features

 

​

Resistor & Diode Kits

 300110 

The “RAPID FLASH” solution.
This Resistor Kit is used primarily as a Lamp Load Simulation. Each unit simulates an 1157 bulb and eliminates rapid flash when using LED lighting.
It is also used for shunting “PHANTOM VOLTAGES” created by leakage currents in on-board computers. Includes 2 units pre-wired for easy installation.

 300120 

The Diode Kit is used to block DC currents and to shunt flyback voltages to ground. Comes pre-wired for easy installation.
 

bottom of page